| |
SP2ONG > SIEC 29.09.13 14:12z 75 Lines 2218 Bytes #999 (0) @ POL
BID : 301_SP2ONG
Read: SP1LOP SP2ONG GUEST SP9LIP
Subj: Re: Broadcast i link Flexnet
Path: SR1BSZ<SP2ONG
Sent: 130929/1354Z @:SP2ONG.#TOR.POL.EU #:301 [Torun] $:301_SP2ONG
From: SP2ONG@SP2ONG.#TOR.POL.EU
To : SIEC@POL
Wroce do tematu wysylania Brodcastow NetRom. Ciekawy opis uzycia komend
route w Xnet z uzyciem ich do wysylnia Broadcastow NetROm :
When sending to TheNet, one would wish to add a route to be sent to
NODES. An example would be:
R BC A 2 NODES
When digipeating nodes through a FlexNet system to TheNet, two things
need coordination. On the XNET system, you must digi your NODES into the
neighbor FlexNet. On the Flexnet system the sysop must have a Link route
set to NODES on the port where TheNet neighbor is. In our example,
station N1VHB is running PC Flexnet. The two examples are:
Xnet:
R BC A 2 N1VHB NODES
Flexnet:
L (Port #) NODES
Flexnet will automatically digi the xnet nodes broadcast out the port.
No <D> for NODES will appear on the flexnet network however the
neighboring TheNet node will accept netrom nodes from the XNET system.
This scenario is ideal when trying to transport L4 frames through
Flexnet systems.
Unlike the limitations of Flexnet, Xnet may carry more than one digipeat
node path in the route for the nodes broadcast. In the following
example, station N1VHB is running PC Flexnet and station KA1OXQ is
running a TheNet in digipeat mode:
R BC A 2 N1VHB KA1OXQ NODES
Netrom nodes are then accepted by other netrom nodes within the
transmission range of KA1OXQ.
A list of which Broadcast-Nodes exist can be seen by entering:
R BC L
Another example: the activated Broadcasts should be sent out every 15
minutes. The entry is planned as follows:
R PA BR 900
In order to send out a Broadcast immediately, one sends the command
R B S
at the node.
Entries are planned with the ADD-Command:
ROUTER LOCAL ADD < PORT > < CALL > [via call] < N|D|ND > [ALIAS]
Port = hardware port number
Call = callsign/ssid of the station
{via call} = digi route if any
n = TheNet (Net/rom) or ax25 node
d = FlexNet
nd = both
alias = node alias name
On no account, nodes that use the Netrom-Protocol (such as TheNet nodes)
should be entered here. Such entries would have fatal consequences for
the network. You may however enter in Flexnet digis as a node. Xnets
router will automatically assign proper routing when it hears the netrom
node.
Read previous mail | Read next mail
| |